Hit-products LogicPLUS S 42/128 Manuel d'utilisateur télécharger pdf (Page 38)

LogicPLUS-S Two-Wire Controller





ADDRESS SWITCHES

ANTENNA JACK

Locking Tabs UP

R.F. INTERFACE

WIRING INSTRUCTIONS

1. Turn off Power.

2. Remove the Logic face plate and stainless steel panel

3. Mount the antenna bracket utlizing the holes in the Logic stainless steel cab ( upper right hand side or top ).

See Remote Technology’s antenna mounting directions.

4. Connect antenna leads.

5. Using the double backed tape, mount the receiver card directly to the stainless steel cab. Locate properly

to leave access to the address switches .

6. Connect antenna lead to ATENNA JACK.

7. Connect R.F. Interface Cable. Observe Polarity Locking Tabs - Up Positions.

8. Reinstall front panel.

9. Apply Power.

LOGIC PLUS-S WIRING DIAGRAM FOR REMOTE CONTROL TECHNOLOGY INTERFACE

Locking Tabs 

R.F. INTERFACE

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 44 45

Pas de commentaire

Hit-products LogicPLUS S 42/128 Manuel d'utilisateur Page 38